Flow Controller/Monitor

• Drawing about sensor locations: https://docs.google.com/drawings/d/1tOOoeUHOlIiYZZEKrPSB4e7GuGj3c78bpsnPMUKvgos/edit

Pressure Sensor

• The table below is for a summary. For a more complete pressure information please visit: https://docs.google.com/spreadsheets/d/1Dh6Y27IiEedgq5waZs8_9CsKKFSGWBRfoOAU4PYjFwM/edit?usp=sharing
• Drawing about sensor locations: https://docs.google.com/drawings/d/16cCaIn4SXTD8Wq2xzqePSZeJITV-1SPnE9UjyXzBx5w/edit

Note about installation:

• The biggest issue is where to put MKS 690 1000 Torr. Ideally it should be close to the 100 Torr one
• Please consult with Dustin to make sure about the final location
• Sensor number 3 (He3) and 8 (Measuring LN2 reservoir) in the google docs and sheets above can not be installed not (waiting pipe/line installation). The rest could be installed
• Sensors number 10 and 11 are LANL sensors. Please consult Misha to make sure which are the correct sensors since in the root, there are several other sensors from oerlikon
• Please consult Ernesto for the current location of sensors and long cables

Temperature Sensor

• Drawing about sensor locations:  https://docs.google.com/drawings/d/1GqKY_9TjaVcJRM2lM2pf_QPTJEXJiqYSX4lqnYAeNM0/edit
  • Old version:  https://docs.google.com/drawings/d/1c_QUxwmyqHE4M3oXTLWR50RxG7F-Zl6y2h9EEIfEYPY/edit
• For the annealing system we should have the analogue setup be entirely independent of the other system, this will require 4 sensors. Two for the Waqar system and 2 for the Henery system, if possible.
• All other, ~20 sensors should be setup with the same type of DAQ that Kenichi is testing unless we determine it is not suitable regarding temperature dependent error. The error budgets are different for several of these, but Magnet coils is by far the most critical low relative error requirement. So, if it looks like this setup will work there it will work everywhere.