...
The Liquefier valves are above the magnet dewar in the display.
Check Alarm Handler to make sure IVC and LWC's are OK.
Check the weather here.
Magnet ramp and coil are here.
...
Insert and fill out the entry text following this format:
Shift Leader:Target System Mode:
Beginning of Shift: <Shift>
Target System Mode: (Idle / Hold / Production)
~ Cryo Pressure ~
IVC Pressure: Torr
~ preset Target TV ~
Liquefier A Status: (Liquefy | Idle)
Liquefier A Liquid He level:
Liquefier B Status: (Liquefy | Idle)
Liquefier B Liquid He level:
...
~ Liquefier Display: Valves ~
VPC Status: (Open | Close)
VJVT Status: closed(Open | Close)
VJVA Status: closed(Open | Close)
VJVB Status: closed(Open | Close)
~ preset Target TV ~
Magnet LHe Level: 58.025054 L??%
Magnet LN2 Level: 86.4 ??%
Purifier LN2 Level: 83.52904%??%
~ QT Systems ~
Outside gHe tank pressure: 83.52904 ?? psi
~ Cryo Flow ~
Mode of Magnet Return Bypass Valve: 5.00%
(Pressure PID / Flow PID / Fully Open)
Mode of Gate Valve Bypass: 0.237 turns Auto (ON | OFF), Set point = ? Torr
~ Cryo Level ~
Fridge Valves:
Run valve = 2.000 ? turns
, Bypass valve = Closed? turns
~ Cryo Magnet ~
Magnet Current: 0 Amps
~ NMR Display ~
Upload a screenshot/picture (per each channel that was used during your shift) of the NMR display to your ECL elog entry.
Mode: (Take Data | Pause | NMR Tune | Monitor)Mode: take-data
TE measurement: (Yes | No), elog #?
~ Microwave Display ~
Microwave frequency: 0 MHz
Number of "Recovery Sequence" made: No 0
~ Lifter Display ~
Target Lifter Position: Anneal
~ Alarm Handler ~
Active alarms are good with no warnings.
...