The
...
lifter system has four branches
- Lifter mechanical+Electrical setup (in the target cave)
- Lifter control box (Slow controls rack)
- Lifter ADC Box (Slow controls rack)
- Lifter monitoring box (Control room)
...
Lifter mechanical setup
Qty Description Manufacturer Part number 7 Limit switch Honeywell 311SM6-T 2 String Potentiometer TE connectivity PT1A-15-UP-10K-C25 1 stepper motor Applied Motion Products, Inc. HT23-600 2 Right-Angle Gear Drive Andantex USA 2 Screw Jack Duff-Norton - This is the ORC document which covers the electrical wiring in the lifter setup Lifter Electrical ORC.pdf
- The wiring diagram of the lifter setup (in the cave) + Wires from the cave to the slow controls rack : lifter_Wiring.PDF
The seven(7) position switches are labeled as in the following image.
- The limit switches are connected to the motor driver in the Lifter Control Box.
- The IP address of the driver: 192.168.24.142
- The motor driver is configured to a special configuration (Lifter config_Updated.stfprj) for the lifter operation. The configuration is done by the manufacturer's software STF Configurator Setup 2.0.22.0630(AMP).exe
- The following image shows the STF interface after configuring the driver
- The configuration is only needed when replacing the motor driver with a new driver
- This is the report prepared by the designer of the lifter E1039 Target Frame and Lifter Final Report.pdf
Lifter Control box
...
The complete lifter system diagram
...