The lifter system has four branches 

1. Lifter mechanical+Electrical setup (in the target cave)
2. Lifter control box (Slow controls rack)
3. Lifter ADC Box (Slow controls rack)
4. Lifter monitoring box (Control room)

Details of each unit

• Lifter mechanical setup

  Qty	Description	Manufacturer	Part number
  7	Limit switch	Honeywell	311SM6-T
  2	String Potentiometer	TE connectivity	PT1A-15-UP-10K-C25
  1	stepper motor	Applied Motion Products, Inc.	HT23-600
  2	Right-Angle Gear Drive	Andantex USA
  2	Screw Jack	Duff-Norton

  
  

  • This is the ORC document which covers the electrical wiring in the lifter setup Lifter Electrical ORC.pdf
  • The wiring diagram of the lifter setup (in the cave) + Wires from the cave to the slow controls rack : lifter_Wiring.PDF

  • The seven(7) position switches are labeled as in the following image.
    

  • The limit switches are connected to the motor driver in the Lifter Control Box.
  • The IP address of the driver: 192.168.24.142
  • The motor driver is configured to a special configuration (Lifter config_Updated.stfprj) for the lifter operation. The configuration is done by the manufacturer's software STF Configurator Setup 2.0.22.0630(AMP).exe 
  • The following image shows the STF interface after configuring the driver
    
  • The configuration is only needed when replacing the motor driver with a new driver
  • This is the report prepared by the designer of the lifter   E1039 Target Frame and Lifter Final Report.pdf 

• Lifter Control box

The attached ORC document describes the details of the lifter control box ORC-1865_ORC_Lifter Control System.pdf

The complete lifter system diagram