CABLING Table:
| Analog Board | Digitizer | type of cable | comments |
|---|---|---|---|
| L-coil | Semi-rigid | back of tuner board | |
| Tune | DAC B | SMB | |
| RF | RF gen | SMB | Crystal Box |
| Log LO | ADC 4-5 | SMB | |
| Log HI | ADC 6-7 | SMB | |
| Log OFF | DAC D | SMB | |
| IF LO | ADC 2-3 | SMB | |
| IF HI | ADC 0-1 | SMB | |
| DAC C | SMB | ||
| IF OFF | DAC A | SMB | |
Plugging the Ribbon cable :
Digitizer:
Analog board:
RCLK pin 2 goes to Brown cable.
Crystal Box:
External Tuner Board connected to crystal:
Vtune goes to the Crystal Box, use semi-rigid cable. cable length needs to be determined later:
Preliminary Settings
1.Turn on router and switch (Turn on monitor)
2.Turn on RF generator (or power cycle it.)
The RF generator should be set to: (see pic)
3.Boot Intel nuc computer (see picture) and login (as Pat, Astrid or Misha for the login).
Before turning on the VME crate:
Start NIMAX
→ click devices and interfaces,
→ click on scan for instruments
→ Click on GP1B-USB…
→ click on bottom tab right (Properties)
→ should see in the identification area: SMT02(3) at gpib address 28 -> GPIB adapter
and R+S are working
NB ECLIPSE