NMR and VI: 

Leader: Devin

The NMR is used to measure the polarization of the target. Labview VI's controls the components and readouts of the NMR. 

Resources: UVA-NMR System Manual

Tasks include:

• Create a debugging setup.
• Better Documentation.
• Characterization of the Q-Meters.
• German Q-Meter.

Microwave and Magnet:

Leader: Nisal

The microwave system is a 140 GHZ EIO tube that drives the polarization through the DNP effect. The Magnet provides the alignment and contains the fridge, which provides the cooling power to the target. 

Resources: 

Tasks include:

• Connect readouts

Pump and cooling:

Leader: Sujan

The pump stack provides the high vacuum needed for the experiment. 

Resources: good video for high vacuum, MVP 070, A 100L, CIT-ALCATEL, pfeiffer Okta 500, turbovac-361c, N0150

Task include:

• The Middle Backing pump control needs repair.
• Turbo needs a backing pump and sensor/readout.
• Flow monitors and Flow controllers need to be installed. 
• NPT lower line needs to be planned and installed.
• The exhaust line needs to be hooked up. 
• The pumps need to be bumped "Cycled on"
• BackFill manifold needs to be created and planned. 

Liquidfer and Helium supply:

Leader: Jay

The QT system is what liquefies the helium recovered from the root exhaust, magnet boil-off, and separator. 

Resources:

Tasks include:

• Connect the Recovery compressor to the Recovery line and Recovery Tank.
• Install fittings on the Recovery Tank.
• Install sensors according to the P&ID.
• Install purifier and Supply Line.
• Leak Check system.
• Pump and Purge.
• Pump Out system.
• Order enough Helium.
• Initial test of the system.

Target and insert:

Leader: Nuwan

The target is the core of the experiment and requires to be produced in the lab. 

Resources:

Tasks include:

• Find and purchase a Test Gas similar to NH3.
• Produce a Stable Slug.
• Produce wafers that are stable. 
• Repair the insert.