Documents
- ShimPS_Manual (1).pdf : ISS10 Manual
- Shim_PowerSupply.pdf : Summary of ISS10 Manual (by Zulkaida)
- ISS10 is not the model used in SpinQuest. We expect the spec is almost similar but sometims different.
Cabling
- magnet_shim_PS_cable.pdf (magnet_shim_PS_cable.odg) : The pin assignment of the magnet shim PS connectors
- http://twist.phys.virginia.edu:8081/General/19 : How the pin assignment was confirmed
Output Validation
- http://twist.phys.virginia.edu:8081/General/20 : Output of magnet shim PS
- V to the switch heaters (Y1 and YZ vs Common)
- Measured = -5.7 V.
- Manual = -12 V.
- V to the coil (+VE vs -VE)
- Measured < +-0.1 V normally. But it was -13.1 V when the big knob was set to any position (like Z0 and Z1) except "MAIN COIL HEATER".
- Manual = +4 V.
- The output voltages were found active, although they were different from the manual spec. It is possible that they are fine for the operation, because our usage is special in the past test and the SpinQuest run, namely the shim coil need not be energized but only inductive when the main coil is ramped up.