| Do Immediately | Additional Information | ||
|---|---|---|---|
Fridge sensors | 1KOhm Ruthenium Oxide | ||
| Determine and measure true path for all cables coming from target cave | Front Penetration → Racks on Cryo platform → Counting House Side Penetration → Racks on Cryo platform → Counting House | ||
| Liquid Helium Level Probe mounting clips | Being made at UVa - 7/17/19 | ||
| Replace Black BUNA-N O-rings | Measure existing O-rings and find PTFE (Teflon) equivalents | ||
| Make and test indium seal on shell/nose | |||
| Measure distance for NMR hardlines through penetration | From magnet position, through the side penetration down to the floor right outside cave. Multiply this measurement by the number of cables desired (>=12) | ||
| Buy a flaring tool for copper tubing | |||
| Assemble and test microwave system | Needs to be shipped from UVa - 7/17/19 Borrow purple gore cable from UVa Need waveguide too | ||
| Get Liverpool NMR Q-meter (and ancillary equipment) from LANL | |||
| Once EIO arrives, connect EIP and test air core cable | |||
| Setup sensors on stick | Check with lakeshore | ||
| Stink test in the target loading area | with special spray |
| Things to do when not working on the immediate things | Additional Information |
|---|---|
| Setup Target Rack | Stepper motor drives and power supplies ADC for position readbacks Microwave EIP Lakeshore 218 x2 Level Probe Readout Turbo readout and Controller IV gauge readout Teledyne Hastings readout 4He & 3He manometers Possibly Microwave Power Supply
|
| Get hoses for microwave (EIO) | Either hard plastic or rubber |
| Target Controls Computer | Josh will find it |