| Do Immediately | Additional Information |
|---|---|
Fridge sensors | 1KOhm Ruthenium Oxide |
| Determine and measure true path for all cables coming from target cave | Front Penetration → Racks on Cryo platform → Counting House Side Penetration → Racks on Cryo platform → Counting House |
| Liquid Helium Level Probe mounting clips | Being made at UVa - 7/17/19 |
| Replace Black BUNA-N O-rings | Measure existing O-rings and find PTFE (Teflon) equivalents
|
| Make and test indium seal on shell/nose | |
| Measure distance for NMR hardlines through penetration | From magnet position, through the side penetration down to the floor right outside cave. Multiply this measurement by the number of cables desired (>=12) |
| Buy a flaring tool for copper tubing | |
| Assemble and test microwave system | Needs to be shipped from UVa - 7/17/19 Borrow gore cable from UVa Need waveguide too |
| Get Liverpool NMR Q-meter (and ancillary equipment) from LANL | |
| Once EIO arrives, connect EIP and test air core cable | |
| Setup sensors on stick | Check with lakeshore |
| Stink test in the target loading area | with "special" spray |
| Setup and test manometer | |
| Setup external magnet sensors | |
| Shim Microwave actuator bushings for hard stop and top target |
...